
2 Mechanical Installation
1.2 Resources
Figure 2 illustrates a Daktronics drawing
label. The drawing number is located in the
lower-right corner of a drawing. This manual
refers to drawings by listing the last set of
digits and the letter preceding them. In the
example, the drawing would be referred to
as Drawing C-325405.
Reference Drawing:
System Riser Diagram ............................................................................Drawing C-325405
Daktronics identifies manuals by the DD or ED number located on the cover page of each
manual. For example, this manual would be referred to as ED-14253.
1.3 Daktronics Nomenclature
Most components within this display carry a white label that lists the part number of the unit.
If a component is not found in the Replacement Parts List in Section 5.4, use the label to order
a replacement. Figure 3 illustrates a typical label. The part number is in bold.
Assembly; a collection of circuit boards
Fabricated metal assembly
Termination block for power
or signal cable
Power or signal plug for the
opposite jack
Following the Replacement Parts List is the Daktronics Exchange Policy and the Repair &
Return Program. Refer to these instructions if replacing or repairing any display component.
1.4 Product Safety Approval
The PC-2002 is ETL-listed, tested to CSA standards, and CE-labeled for indoor use only.
Contact Daktronics with any questions regarding the testing procedures.
Figure 2: Daktronics Drawing Label
Kommentare zu diesen Handbüchern