Daktronics Fuelight FL-3000 and FL-4500 Line-to-Line Cable Bedienungsanleitung PDF herunterladen

Fuelight

™

FL-3000 and FL-4500

Line-to-Line Cable Installation Page 1 of 2

DD2739343 Rev 00

21 February 2014

PO Box 5128 201 Daktronics Drive, Brookings, SD 57006-5128

tel: 800-325-8766 fax: 605-697-4700

www.daktronics.com

Additional Information

To watch a video about installing the line-to-line cable with drain wire, go to http://

www.youtube.com/watch?v=hhQXzGLpxMw

Display Interconnections

Signal travels from the host driver jack J9 to additional display

drivers through the Line-to-Line cable. Line-to-line connections are made using jacks

J9 and J10 on the driver.

The preferred cable routing has signal leaving each driver from jack J9

and entering the next driver on jack J10

Each time you connect the line-to-line cable to J9, you must also

connect the drain wire to the upper-left stud that holds the driver in

place.

1. Connect the provided line-to-line cable, shown in Figure 1, to

host driver jack J9. The host driver can be identified by having

the communication option attached to jack J16.

2. Place the drain wire of the line-to-line cable on the upper-left

stud that holds the driver in place, as shown in Figure 2.

3. Place the 6-32 nut on the stud and tighten it with a

" nut

driver, as shown in Figure 3.

Figure 1: Line-to-Line Cable

Figure 2: Installed Line-to-Line Cable with Drain Wire

Figure 3: Installed Drain Wire

1 2

Fuelight™ FL-3000 and FL-4500 Line-to-Line Cable Installation Page 1 of 2DD2739343 Rev 0021 February 2014PO Box 5128 201 Daktronics Drive, Brookings,

Seite 2

Fuelight™ FL-3000 and FL-4500 Line-to-Line Cable Installation Page 2 of 2DD2739343 Rev 0021 February 2014PO Box 5128 201 Daktronics Drive, Brookings,

Keine Kommentare

Daktronics Fuelight FL-3000 and FL-4500 Line-to-Line Cable Bedienungsanleitung